Back to all discussions

  •   about 12 years ago

Blink green or red led only once

Is there a way make the button blink the green or red led only once? Thanks.

  • 3 comments

  • Manager   •   about 12 years ago

    Hello Hawk_Innovations,

    The firmware in the button supports the Immediate Alert Service which allows the remote application to turn on a pre-determined sequence.
    There is no support to just turn on an LED only once.

    Immediate Alert Service
    The Immediate Alert Service causes an alert in the V.BTTN when it is written with a value other than “No Alert.”
    The V.BTTN alert behavior is as follow:
    00 No Alert.
    01 Chirp every 2 seconds for 20 seconds.
    02 Chirp + blink red LED every 2 seconds for 20 seconds

  •   •   about 12 years ago

    If you set the "Stealth Mode" configuration to "Normal" the button beeps once and flashes green once.

  • Manager   •   about 12 years ago

    Yes, very good point!
    Actually, 00 turns off stealth mode, and the button will flash led and beep to indicate that the stealth mode is off. This can be used to, "at will", flash led and beep!!!

    Also, 01 enables sound stealth. (meaning beep off)
    02 enables led stealth (meaning led off)

Comments are closed.